News Release 

2016/08/31

Products

Small High-temperature Pressure Transducer with built-in amplifier PWFA-PA

A small pressure transducer most suited to dynamic measurement around the engine at high temperature up to 120ºC

The PWFA-PA is a M8 bolt-shaped flush diaphragm pressure transducer. It employs strain gauges as sensing element and is equipped with a built-in strain amplifier. Since the PWFA-PA is small sized and can be used for dynamic measurement in high temperature ranges, it is most suited to in-vehicle measurement of hydraulic oil pressure of engine, motor, transmission, oil pump and so on. A compact in-vehicle measurement system becomes possible because there is no need of combining an external amplifier. Its shape of M8 hexagonal bolt enables easy installation in a thread hole.

2016/08/30

Products

3-Component Load Cell SLP-NA-T

Measures three forces simultaneously Most suited to model testing

The SLP-NA-T is a strain gauge based load cell for simultaneous measurement of forces in three mutually perpendicular axes.  Since the load cell is constructed small and light, it is well suited to use in model testing.

2016/08/01

Guide

New Catalog "PRODUCT GUIDE 2016"

2015/09/17

Products

Frictional Torque Transducer FGDH-3A, FGDH-3A-30/40, FGDH-3A-40/50

Globally standardized 2.4GHz band data communication system

The FGDH-3A adopts frictional type strain gauge. It does not need complicated strain gauge bonding and wiring works. It measures the torque generated on the drive shaft of a car and forwards the digital data by wireless. It uses 2.4GHz of radio band and enables long communication distance. The receiver can be installed in the car. The transducer is attached by just pinching the drive shaft with the sensor and fixing the screws. Applicable diameter of shaft is from 20 to 30mm, from 30 to 40mm, or from 40 to 50mm depending on the sensor type. The power supply is USB rechargeable type, so charging is possible without removing the sensor.

News Release