Carrying Case / Mounting Rack

• Carrying Case

  

  This case is used to configure DA series or DC series units in multi-channel. A power switch, calibration switch, and balancing button are provided that can be used with all channels at the same time.

  Type	Number of channels	Dimensions (mm)
  P-4B	4	208(W) x 148(H) x 308(D) (except projecting parts)
  P-6B	6	288(W) x 148(H) x 308(D) (except projecting parts)
  P-8B	8	368(W) x 148(H) x 308(D) (except projecting parts)
  P-10B	10	448(W) x 148(H) x 308(D) (except projecting parts)

   

• Computer Control Carrying case for DA-17A/DA-37A

  

  This is a case for making a multi-channel system with DA-17A/DA-37A dynamic strainmeters. When the DA-17A or DA-37A units are installed in this case, settings such as low pass filter, balancing, calibration and acquisition of set values and monitor values are available from a computer through LAN interface. A power switch, calibration switch and balancing button are also provided. Carrying cases available for 4-, 6-, 8-, and 10-channel systems.

  Type	Number of channels	Dimensions (mm)
  P-4AL	4	208(W) x 148(H) x 308(D) (except projecting parts)
  P-6AL	6	288(W) x 148(H) x 308(D) (except projecting parts)
  P-8AL	8	368(W) x 148(H) x 308(D) (except projecting parts)
  P-10AL	10	448(W) x 148(H) x 308(D) (except projecting parts)

   

• Mounting Rack

  

  This is a JIS rack to configure a system with up to 10 units of DA or DC series dynamic strainmeters. A power switch, calibration switch, and balancing button are provided that can be used with all channels at the same time.

  Type	Number of channels	Dimensions (mm)
  R-10B	10	480(W) x 149(H) x 311(D) (except projecting parts)

   

• Fixing Stand

  When a single unit of DA or DC series dynamic strainmeter is used, this stand is attached to the bottom surface of the single unit. It assists to keep the unit upright.

• One-touch Terminal SB-OT1B

  

  This is a terminal capable of connecting a lead wire by merely pressing down the knob and inserting the lead wire into the hole of the terminal. The lead wire is secured by the spring force of the knob. This terminal is mounted on the input terminal of switching box or bridge box (SB-120SB, SB-121A, SB-351A or SB-122A). One terminal is used for one lead wire, so it is supplied by every 5 terminals.